CPE Details
Linux Kernel 6.1.126
6.1.126
2025-02-11
15h33 +00:00
15h33 +00:00
2025-02-11
15h33 +00:00
15h33 +00:00
Alerte pour un CPE
Stay informed of any changes for a specific CPE.
CPE Name: cpe:2.3:o:linux:linux_kernel:6.1.126:*:*:*:*:*:*:*
Informations
Vendor
linuxProduct
linux_kernelVersion
6.1.126Related CVE
| CVE ID | Published | Description | Score | Severity |
|---|---|---|---|---|
13h52 +00:00 |
In the Linux kernel, the following vulnerability has been resolved: gfs2: Truncate address space when flipping GFS2_DIF_JDATA flag Truncate an inode's address space when flipping the GFS2_DIF_JDATA flag: depending on that flag, the pages in the address space will either use buffer heads or iomap_folio_state structs, and we cannot mix the two. | 5.5 |
Medium |
|
13h27 +00:00 |
In the Linux kernel, the following vulnerability has been resolved: mm: clear uffd-wp PTE/PMD state on mremap() When mremap()ing a memory region previously registered with userfaultfd as write-protected but without UFFD_FEATURE_EVENT_REMAP, an inconsistency in flag clearing leads to a mismatch between the vma flags (which have uffd-wp cleared) and the pte/pmd flags (which do not have uffd-wp cleared). This mismatch causes a subsequent mprotect(PROT_WRITE) to trigger a warning in page_table_check_pte_flags() due to setting the pte to writable while uffd-wp is still set. Fix this by always explicitly clearing the uffd-wp pte/pmd flags on any such mremap() so that the values are consistent with the existing clearing of VM_UFFD_WP. Be careful to clear the logical flag regardless of its physical form; a PTE bit, a swap PTE bit, or a PTE marker. Cover PTE, huge PMD and hugetlb paths. | 5.5 |
Medium |
|
13h27 +00:00 |
In the Linux kernel, the following vulnerability has been resolved: hrtimers: Handle CPU state correctly on hotplug Consider a scenario where a CPU transitions from CPUHP_ONLINE to halfway through a CPU hotunplug down to CPUHP_HRTIMERS_PREPARE, and then back to CPUHP_ONLINE: Since hrtimers_prepare_cpu() does not run, cpu_base.hres_active remains set to 1 throughout. However, during a CPU unplug operation, the tick and the clockevents are shut down at CPUHP_AP_TICK_DYING. On return to the online state, for instance CFS incorrectly assumes that the hrtick is already active, and the chance of the clockevent device to transition to oneshot mode is also lost forever for the CPU, unless it goes back to a lower state than CPUHP_HRTIMERS_PREPARE once. This round-trip reveals another issue; cpu_base.online is not set to 1 after the transition, which appears as a WARN_ON_ONCE in enqueue_hrtimer(). Aside of that, the bulk of the per CPU state is not reset either, which means there are dangling pointers in the worst case. Address this by adding a corresponding startup() callback, which resets the stale per CPU state and sets the online flag. [ tglx: Make the new callback unconditionally available, remove the online modification in the prepare() callback and clear the remaining state in the starting callback instead of the prepare callback ] | 7.8 |
High |
|
15h58 +00:00 |
In the Linux kernel, the following vulnerability has been resolved:
net: sched: fix ets qdisc OOB Indexing
Haowei Yan |
7.8 |
High |
|
15h58 +00:00 |
In the Linux kernel, the following vulnerability has been resolved: scsi: storvsc: Ratelimit warning logs to prevent VM denial of service If there's a persistent error in the hypervisor, the SCSI warning for failed I/O can flood the kernel log and max out CPU utilization, preventing troubleshooting from the VM side. Ratelimit the warning so it doesn't DoS the VM. | 5.5 |
Medium |
|
15h58 +00:00 |
In the Linux kernel, the following vulnerability has been resolved: USB: serial: quatech2: fix null-ptr-deref in qt2_process_read_urb() This patch addresses a null-ptr-deref in qt2_process_read_urb() due to an incorrect bounds check in the following: if (newport > serial->num_ports) { dev_err(&port->dev, "%s - port change to invalid port: %i\n", __func__, newport); break; } The condition doesn't account for the valid range of the serial->port buffer, which is from 0 to serial->num_ports - 1. When newport is equal to serial->num_ports, the assignment of "port" in the following code is out-of-bounds and NULL: serial_priv->current_port = newport; port = serial->port[serial_priv->current_port]; The fix checks if newport is greater than or equal to serial->num_ports indicating it is out-of-bounds. | 5.5 |
Medium |
|
15h58 +00:00 |
In the Linux kernel, the following vulnerability has been resolved: vfio/platform: check the bounds of read/write syscalls count and offset are passed from user space and not checked, only offset is capped to 40 bits, which can be used to read/write out of bounds of the device. | 7.8 |
High |
|
15h58 +00:00 |
In the Linux kernel, the following vulnerability has been resolved: drm/amd/display: Initialize denominator defaults to 1 [WHAT & HOW] Variables, used as denominators and maybe not assigned to other values, should be initialized to non-zero to avoid DIVIDE_BY_ZERO, as reported by Coverity. (cherry picked from commit e2c4c6c10542ccfe4a0830bb6c9fd5b177b7bbb7) | 5.5 |
Medium |
|
11h25 +00:00 |
In the Linux kernel, the following vulnerability has been resolved: openvswitch: fix lockup on tx to unregistering netdev with carrier Commit in a fixes tag attempted to fix the issue in the following sequence of calls: do_output -> ovs_vport_send -> dev_queue_xmit -> __dev_queue_xmit -> netdev_core_pick_tx -> skb_tx_hash When device is unregistering, the 'dev->real_num_tx_queues' goes to zero and the 'while (unlikely(hash >= qcount))' loop inside the 'skb_tx_hash' becomes infinite, locking up the core forever. But unfortunately, checking just the carrier status is not enough to fix the issue, because some devices may still be in unregistering state while reporting carrier status OK. One example of such device is a net/dummy. It sets carrier ON on start, but it doesn't implement .ndo_stop to set the carrier off. And it makes sense, because dummy doesn't really have a carrier. Therefore, while this device is unregistering, it's still easy to hit the infinite loop in the skb_tx_hash() from the OVS datapath. There might be other drivers that do the same, but dummy by itself is important for the OVS ecosystem, because it is frequently used as a packet sink for tcpdump while debugging OVS deployments. And when the issue is hit, the only way to recover is to reboot. Fix that by also checking if the device is running. The running state is handled by the net core during unregistering, so it covers unregistering case better, and we don't really need to send packets to devices that are not running anyway. While only checking the running state might be enough, the carrier check is preserved. The running and the carrier states seem disjoined throughout the code and different drivers. And other core functions like __dev_direct_xmit() check both before attempting to transmit a packet. So, it seems safer to check both flags in OVS as well. | 5.5 |
Medium |
|
11h52 +00:00 |
In the Linux kernel, the following vulnerability has been resolved: iio: adc: rockchip_saradc: fix information leak in triggered buffer The 'data' local struct is used to push data to user space from a triggered buffer, but it does not set values for inactive channels, as it only uses iio_for_each_active_channel() to assign new values. Initialize the struct to zero before using it to avoid pushing uninitialized information to userspace. | 7.1 |
High |
|
06h45 +00:00 |
In the Linux kernel, the following vulnerability has been resolved: sysctl: Fix out of bounds access for empty sysctl registers When registering tables to the sysctl subsystem there is a check to see if header is a permanently empty directory (used for mounts). This check evaluates the first element of the ctl_table. This results in an out of bounds evaluation when registering empty directories. The function register_sysctl_mount_point now passes a ctl_table of size 1 instead of size 0. It now relies solely on the type to identify a permanently empty register. Make sure that the ctl_table has at least one element before testing for permanent emptiness. | 5.5 |
Medium |
|
06h45 +00:00 |
In the Linux kernel, the following vulnerability has been resolved: ocfs2: Avoid touching renamed directory if parent does not change The VFS will not be locking moved directory if its parent does not change. Change ocfs2 rename code to avoid touching renamed directory if its parent does not change as without locking that can corrupt the filesystem. | 5.5 |
Medium |
|
06h45 +00:00 |
In the Linux kernel, the following vulnerability has been resolved: drm/msm/dpu: Add mutex lock in control vblank irq Add a mutex lock to control vblank irq to synchronize vblank enable/disable operations happening from different threads to prevent race conditions while registering/unregistering the vblank irq callback. v4: -Removed vblank_ctl_lock from dpu_encoder_virt, so it is only a parameter of dpu_encoder_phys. -Switch from atomic refcnt to a simple int counter as mutex has now been added v3: Mistakenly did not change wording in last version. It is done now. v2: Slightly changed wording of commit message Patchwork: https://patchwork.freedesktop.org/patch/571854/ | 7 |
High |
2025©
tesweb SA
